Optical Parameter | ||
Output Wavelength | 1060±3nm | |
Laser Diode | Single Transverse Mode | |
Spectral Width (FWHM) | 2nm | |
Operating Mode | CW | |
Fiber Coupled to | SM Fiber or PM Fiber | |
Output Power after SM/PM Fiber | 20mW, 50mW, 100mW, 150mW, 200mW | |
FDA Safety Class | Class IIIb | |
Fiber Connector | FC/PC, FC/APC or SMA905 | |
SM/PM Fiber Length | 1m | |
Power Stability | 1% or 3% (rms, over 2 hours, T= 25℃) | |
Optical Noise | 1% (rms, 20Hz~20MHz) | |
Electrical Parameter | ||
Power Supply | ADR-180A | |
Adjustable Power Supply, with LED Display | ||
Input Voltage | 85~240VAC, 50/60Hz | |
Modulation | TTL or Analog Modulation | |
Mechanical Parameter | ||
Dimensions of Laser Head | 140 × 49 × 42mm | |
Weight of Laser Head | 0.6Kg | |
Dimensions of Power Supply | 150 × 110 × 56mm | |
Weight of Power Supply | 0.6Kg | |
Reliability | ||
Warm Up Time | <10 minutes | |
Cooling | TEC, Forced-air cooled | |
Operating Temperature, Case | 10℃ ~ 35℃ | |
Storage Temperature | -20℃ ~ 60℃ | |
Expected Operation Lifetime | 10000 hours | |
Warranty | 12 months | |
Note | ||
» The Laser is designed to operate without heat sink. Do not restrict air circulation around the device; an additional heat sink can be used to maximize the performance and life time of the laser. » All specifications are based on performance at full output power and after the specified warmup period. Output characteristics may change if the laser is run at a different power level. » The SM/PM fiber is connected to the laser head permanently; please do not remove the SM/PM fiber. Please do not pull the SM/PM fiber. » 2-Year Warranty is available upon request. |
Accessories (optional) | |||
Ordering Code | ||
TA Laser Head, SM/PM Fiber Coupled | ||
ADR-180A Power Supply | ||